Blog

Wavy Farfalle Bracelet

07 May 2024 - 0 Comments

Posted by Sue Allen

To make a bracelet like this you will need
2 colours of farfalle beads
A few size 8 seed beads
Clasp of your choice
A 2mm crimp bead
75cm of 0.3mm tigertail wire

1. With the clasp at the centre of the wire fold the wire in half and add 3 seed beads over both wires.

2. Separate the wires, onto one wire add 3 farfalle colour one beads and on the other wire add 5 farfalle colour 2 beads.

3. Cross the wires through a colour 2 farfalle bead.

4. Pull the wires up.

5. Add the same beads as step 2 making sure they are on the opposite sides as shown here.

6. Cross the wires through a colour 2 farfalle bead and pull up.

7. Repeat steps 2 to 6 until you have the length you require.

8. Add 3 size 8 seed beads and a 2mm crimp bead.

9. Put both wires through the part of the clasp then back through the crimp bead and the 3 size 8 seed beads.

10. Push the seed beads and the crimp beads firmly up against the rest of the bracelet beads, hold the clasp firmly in one hand and pull the wire up untl the clasp is against the beads. If it gets stuck push the beads and crimp away from clasp and pull again until all the wire is through.

11, Squash the crimp bead firmly with flat nosed pliers and trim the wire off as close as to can.

All done!

This one is made with inside lined farfalle beads in green and white.

~💮~🌼~💮~

Comments are moderated and therefore will not appear
immediately.

Did you like this post? Any questions?
Leave a comment or use the contact form to send a private message.
Thank-you
Sue x